The Army Painter TL5042P | Drill Bits Set - 10 Bits 0.7-3mm for Pin Vise | Multi Scale

Ten bits that turn a pin vise into a full drilling kit: doubled-up 0.7 and 0.9mm for fine detail work (with a spare when the inevitable happens), then 1.0 through 3.0mm for everything up to rare-earth magnet pockets. Sized for plastic, resin, and metal models.

They fit the Miniature & Model Drill, and the 3mm bit is exactly what the Model Magnets want.

• 0.7-0.9mm bits drill wire-size holes for grab irons, handrails, and lift rings.
• Duplicates of the two finest sizes — the ones that snap — so a break does not stop the session.
• 3mm bit matches 3mm neodymium magnets for swappable loads and removable parts.
• Cuts styrene, resin, white metal, and brass in a hand pin vise.
• Storage case keeps the set organized and findable.

Do these fit other pin vises?
Yes — any pin vise with a chuck accepting up to 3mm shanks, including most hobby brands.

Which size for #78-ish detail holes?
0.7mm sits between #70 and #69 — right in the range for common 0.012-0.020 inch detail wire.

Can I use them in a rotary tool?
Better not at fine sizes — high RPM snaps sub-1mm bits and melts styrene; hand power is the point.