NixTrainz | Decoder Buddy Mini (1k Ohm Resistors Onboard)
Earn 110 points · Sign in to earn · Rewards
Description
The Decoder Buddy Mini was developed to fit into smaller steam and diesel applications. there has also been interest in HOn3 and S-Gauge applications.
- This mother board does not include the 21 Pin Decoder.
- This mother board requires soldering.
- These printed circuit board is NOT INTENDED FOR USE IN A DC SYSTEM.
The mother board includes:
- One 21 Pin Decoder receptacle
- Two pairs of track input pads
- One pair of motor input pads
- One set of stay alive pads (U+ , GND and if necessary a third control wire )
- One pair of speaker pads
Resistors for use with LED lighting. (Also available with 0 ohm, 750 ohm and custom specified resistors for function outputs. This accommodates some previously installed and "12 volt LEDs".) It is IMPORTANT to realize that resistors must be used when LEDs are connected to the four lighting outputs of the Mini!!! The resistors may be soldered in line when purchased or the included resistors may be soldered inline upon installation. Remember there are different incandescent lamp voltage requirements and current draw that have to be taken into consideration also.
(Until the next batch is produced the Mini will be labeled Tiny and the picture on the package will indicate the correct headlight outputs for direction of locomotive.)