The PWR-56 is a Power Supply that can be used to supply power for your locomotives, turnouts and other accessories. The PWR-56 has 56 Watts of output power! That is enough power to drive 15 or more typical modern HO scale locomotives! Further, each PWR-56 is equipped with Direct Radio, so a RailPro controller can be used to control, setup, and monitor the PWR-56. Also, the PWR-56 can be used as a Direct Radio Repeater. Package Contents: PWR-56 Module PA-2 Power Adapter 110 VAC Power Cable User Manual Ring Engineering's AccuClean Power technology in TM the PWR-56 maintains a clean stable output voltage Clean that stays within about 3% from no load to full load! Typical model railroad power supplies can have voltage drops as high as 30% at full load. Unlike typical model railroad power supplies, when you need full power, your Ring Engineering PWR-56 will deliver! Direct Radio allows RailPro components to communicate with each other without any wires! Direct Radio is very fast giving your RailPro products quick response to your commands. Also, Direct Radio has two-way communication that allows your PWR-56 to transmit and receive information! Because the PWR-56 has Direct Radio, you can control, setup, and monitor your PWR-56 with any RailPro controller, such as the HC-2 with color touch screen. With a RailPro controlling device, you can turn the output to the track on or off, adjust settings, monitor the output power your PWR-56 is delivering, and more! Setting up your RailPro system is easy. To control and setup your PWR-56 simply press the "Find Produce button on a RailPro controller such as the HC-2, then the RailPro Controller will automatically load a picture of your PWR-56! You can take control of your PWR-56 by touching the picture of the PWR-56 on the screen! The PWR-56 has built in Short Circuit Protection with Auto Recovery to protect your trains and equipment in case of a derailment or other rail-to-rail short! Add multiple PWR-56's to your layout to increase the total amount of power for larger layouts.
$119.99$95.99
The CB-1 is used to divide the output of a power supply to isolate small sections of track, limiting the impact of short circuits if derailments occur to just one area of your layout. Add multiple CB-1 to isolate several sections of track. Features: All Solid State Design Simple Connection with Only 4 Wires No Adjustments Necessary Provides Short Circuit Isolation for a Section of Track Status Indicator Light Fast and Secure Spring Clamp Connecters Fully Enclosed Circuit Board Electronics Size: 4.60 x 3.00 x 1.18 inches
$31.99
The AM-1S is a module that you can install on your model train layout to control Accessory Projects. You can control a turntable, swing bridge, oil pumps, lights in buildings, and much more!!! You can use our RailPro Assistant Software to design custom screens for your HC-2 to control your accessories!!! The AM-1S can be controlled and setup by a Ring Engineering RailPro Controller, such as the HC-2 Handheld Controller. The AM-1S is not for use with turnouts. Please use AM-1 for turnout control. Control motors, lights, operate lights with light effects and play custom loaded sounds! Features: Size: 4.60 x 3.00 x 1.18 inches Important Note: Important Note: The AM-1S hardware has 8 outputs that can be software controlled for 4 motor outputs or 8 sourcing outputs. It also has another 8 I/O that can be configured for 8 inputs or 8 sinking outputs. Currently there is only one software configuration available for the module (2 motor outputs, 4 sinking outputs, and 8 inputs). We expect to offer more software configurations in the future.
$80.99
