The Digitrax LNC82 is a 2-pack of 8-foot LocoNet cables — the standard RJ12 6-conductor cables you need to wire up a Digitrax DCC system. Use them to connect throttles to UP5 panels, link LocoNet peripherals (BDL16, BDL168, DS64, etc.), or extend a LocoNet bus across your layout. Two cables in every package.
Looking for more DCC wiring and accessories? Browse our Electronics & Wiring and DCC Decoders collections.
Features
2 cables per package — 8 feet long each.
RJ12 6-position / 6-conductor (6P6C) plugs on both ends — matches every Digitrax LocoNet jack.
Flat ribbon cable construction — runs neatly along benchwork edges.
Works with all Digitrax DCC systems — Zephyr, Super Empire Builder, Super Chief, DCS210, DCS240, etc.
Length sufficient for typical throttle-to-panel runs and panel-to-panel hops on home layouts.
More Information
Brand
Digitrax
Item Number
LNC82
Type
LocoNet cable — RJ12 6P6C
Length
8 feet each
Quantity
2 cables per pack
Plug
RJ12 6-position 6-conductor (6P6C) on both ends
System
Digitrax LocoNet
Condition
New — sealed
UPC
652667180061
FAQ
Are these standard phone cables?They look similar, but Digitrax LocoNet uses 6-position 6-conductor (6P6C) wiring, not the 6P4C found in many phone cables. Use these LocoNet-spec cables to avoid wiring issues — or any high-quality 6P6C cable will work.
What can I connect with them?Throttles to UP5/UP6 plug-in panels, BDL16/BDL168 detection boards to the LocoNet bus, DS64 stationary decoders, SE8C signal decoders, PR4 USB interfaces, and any other LocoNet peripheral.
Will 8 feet be long enough?For most home layouts, yes — 8 feet covers a typical throttle reach from one UP5 panel to another. For larger layouts you may need longer cables (Digitrax LNC25 is 25 ft) or chain multiple LNC82s through UP panels.
Do they work with non-Digitrax DCC systems?No — LocoNet is Digitrax's proprietary throttle bus. NCE, MRC, and other DCC systems use different cab buses and connectors.
Read
more
less
